MIG/MAG welders
MIG/MAG welders use a continuous wire fed automatically through the torch, with a shielding gas. The MAG process uses an active gas (CO2 or an argon and CO2 mix) for steel, while MIG uses an inert gas, most often argon, for aluminium and other metals. Many machines also run gasless flux-cored wire, which helps outdoors in the wind. When choosing, compare the current range in amps and the duty cycle: this percentage is the share of a ten-minute cycle, so 60% means 6 minutes of welding and 4 of cooling at the stated current. Check the supply (230 V or three-phase 400 V), the wire diameters it takes (for example 0.6 to 1.0 mm), the spool size and whether it has synergic control that matches voltage and wire speed. Drive rolls must suit the wire: V-groove for steel, U-groove for aluminium and knurled for flux-cored wire. Ask the seller whether the torch, earth cable and gas regulator are included; the cylinder is usually obtained separately. You will need an auto-darkening helmet, leather gloves, clothing that covers the skin, extraction for the carcinogenic fumes and a work area cleared of flammable materials. Delivery options and cost depend on the seller and the product.